My check engine light came on in my 1996 mercury cougar I had it checked at autozone and the error code that came up was p1443 and this is what the printout said that they gave me:
trouble shooting p1443
oem brand: ford
definition:
evap canister purge valve mechanical fault or vmv fault condition
explanation:
ecm detected a Fuel Tank pressure change greater than a minus 7 inches of h2o in 30 seconds with purge less the 0.02 lbs. per minute
probable causes
1.failed EVAP pressure sensor
2.blocked hose between purge valve and FTP sensor
3.evap purge valve stuck closed
The autzone guy told me he cleared the code and that it could just be a faulty gas cap so i left and before i got a chance to get a new gas cap the check engine light came on any suggestions? thank you
maybe a plugged Fuel Filter but im not sure because then you wouldnt run very long. I know that on my dads car the top seal on his Fuel Pump rotted out and his check engine light came on. good luck
Check out the Valve Minus listings below and save:
The mainstay of our valve line. Dependable and inexpensive, with a standard stainless steel lever and nut to withstand rugged marine environments.
Stock Status : In 10 Stores
Itt Jabsco Par Y Valve Y-valve 45490-1000 In Box (ITT Jabsco)
from $ 47.88
The Jabsco Y-Valve is designed to provide flexibility of onboard waste management by diverting waste either into an onboard holding tank or directly overboard where legal to do so. Check local and Federal regulations to determine where direct overboard discharge of untreated waste is permitted. No overboard discharge of untreated waste is allowed within three miles of shore.Some near shore areas and inland areas are designated as "No-Discharge Zones" where the discharge of any onboard waste, even treated waste is strictly prohibited. Many of these areas require a waste retention system that can be positively secured in an onboard retention mode. The Jabsco Y- Valve accommodates this requirement by providing the ability to add a padlock that secures the selector handle in either direction to ensure waste is directed to an onboard holding tank.
Stock Status : In 9 Stores
Apollo Bronze Ball Valve - 3/4''
from $ 24.25
The mainstay of our valve line. Dependable and inexpensive, with a standard stainless steel lever and nut to withstand rugged marine environments.
Stock Status : In 5 Stores
Bronze Ball Valve - 1 1/2''
from $ 59.99
The mainstay of our valve line. Dependable and inexpensive, with a standard stainless steel lever and nut to withstand rugged marine environments.
Stock Status : In 5 Stores
Conbraco Industries, Inc. 2-1/2 Ball Valve W/Ss Lever
from $ 282.95
Conbraco Industries, Inc. Conbraco Industries, Inc. 2-1/2 Ball Valve W/Ss Lever Made by Conbraco Industries, Inc. Part number 37-7010910
Stock Status : In 3 Stores
Bronze Ball Valve - 1''
from $ 27.06
Quality valve features mounting ears for quick easy installation, and positive mounting. Can also be used for bonding.
Stock Status : In 8 Stores
Conbraco Apollo 2 Inch Bronze Seacock
from $ 219.95
Apollo Valves Full Port Flanged Bronze Seacocks Seacock, 2" Pipe Size . All-bronze bodies with chrome-plated bronze balls and stainless-steel levers and nuts. Glass-reinforced Teflon seats and seals. Top fitting is NPT (tapered thread) and bottom is NPS (straight thread). Marine UL-listed. Comply with ABYC H-27 and ISO-9093-1 requirements.
Stock Status : In 3 Stores
Jabsco Y-valve USD 53.99
Manufacturer:Jabsco Model:45490-1000 Y-Valve The Jabsco Y- Valve accommodates this requirement by providing the ability to add a padlock that secures the selector handle in either direction to ensure waste is directed to an onboard holding tank. The Y-Valve may also be used to direct waste from a holding tank to an onboard waste discharge pump for holding tank evacuation or, alternatively, to a waste deck plate for removal by a shoreside pump-out facility. The Y- Valve may also be used in a bilge pumping system to select between two separate bilge pickups in different bilge compartments providing for evacuation of two separate bilge areas with only one bilge pump. Features: Chemical and corrosion resistant polypropylene and stainless steel construction Selector lever can be padlocked (lock not included) and/or sealed in either position Ports can be rotated so discharge plumbing can be routed away in parallel, at 900 or in opposite directions, or either up or down without disassembly Valve is supplied with bot
Notes : Earn 2% eBay Bucks on qualifying purchases! Backed by eBay Buyer Protection Program. Terms and Conditions apply.
Stock Status : in-stock
Apollo Ball Valves 7010610 1-1/4in USD 74.32
Apollo ball valves are made from cast bronze with a stainless steel handle and stem nut. Ball is chromium plated for long lasting corrosion resistance. Reinforced PTFE seats and stuffing box ring.
Notes : Great prices on over 50,000 boating & building items. Fast shipping.
Stock Status : in-stock
Forespar Flowtech Valve USD 179.99
Forespar Flowtech Valve . Flowtech free-flow sea valves incorporate the valve body, thru-hull and three sizes of hose pipe connections in one set. 3/4", 1" and 1-1/2" hose barbs are included. The Flowtech valve pipe can be faired smooth to the outer hull surface so that when the valve is closed, the internal plunger and valve creates a flush, fair and fast outer surface. Made of highly durable, non-corroding Marelon.
Notes : Low Price Guarantee
Stock Status : in-stock
Left 4 Dead 2: T-Minus LAUNCH DAY (Game Release Countdown) S1E22
More Valve Minus listed below:
Why Resident Evil 6 would rule if it had George Romero on board
George Romero (director of Dawn of the Dead and the father of zombie movies) says he'd be interested in making a game . This also coincides with the news that Jun Takeuchi (director of Resident Evil 5) won't be returning for the sixth instalment of the survival horror series.